Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! I am looking for some advice on making an API call for Catalyst Center 2.3.7.I am trying to automate the process of editing a sensor template in Catalyst Center. Specifically, the PSK of the template's SSID needs to be edited at certain time inte...
Hi there,does anybody know how to verify dot1x credentials of the AP via CLI? I want to check if the AP remembers the credentials after joining the WLC.Thanks in advance for the assistance.
Hi,I am new to DNAC and looking for some advice...I am going to change some APs and therefore I want to use the "Access Point Refresh" Workflow. I will provide the Serial Number of the new APs against each old AP. But there is one problem.It takes so...
Hi there,I want to configure my C9105AXI-E Access Point for an AP-on-a-Stick site survey. I have already booted up with the ewc image. Now I am getting a warning that asks to do the basic day 0 provisioning prior to the deployment of the AP. What I w...
Hi, i would like to share with you what i have done. Currently my C9105AXI AP is connected to a C2960-C PoE Switch. My laptop is also connected to the switch. I have given both devices an ip address from the 10.0.0.0/24 network. But i couldn´t access...
