Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On some of my internal machines requires a access to this ip address(203.13.163.xxx) in particular port access 4569 for IAX.Please advice how do i open. I request only expertise to answer my question.Thanks
I would like to access my PC from xyz location. How do i open port 22 to access my pc. I am using pix 501. Can anyone provide the commands to open the port so that i can access my pc. Thanks
I would like to access my PC from xyz location. How do i open port 22 to access my pc. I am using pix 501.Can anyone provide the commands to open the port so that i can access my pc.Thanks
I have configured cisco 2620 router through hyperterminal at the time of configuring i put the password "cisco".Today i have installed Cisco Configmaker. There is one option called Autodetect device wizard in Cisco config maker. I have clicked on tha...
Lets start from the begining step by step procedure. Firstly your below setup is incorrect."Here is my current setup: PC <-- x-over cable --> firewall <--- router ----> Internet" MAKE IT TO1. Connect Straight cable from PC into P...
Yes you are right i am trying to ping from the PCI am accessing 192.168.0.110 from this PC 192.168.0.33 through putty.exe.I tried through dos prompt by typing telnet 203.13.163.xxx 4569=====================================================Microsoft Wi...
I have added the following command. After adding the above commands i try to ping from IP 192.168.0.110 to 203.13.163.xxx its saying request timeout.access-list outbound permit tcp host 192.168.0.110 host 203.13.163.xxx eq 4569access-list outbound pe...
Thanks for the replyI am pretty sure the above instruction is nothing to do to open the port 22.I came back home and would like to end up this topic thanks to Jakko,and other netpro members for their support.Hence my problem is not solved and i am 10...
