Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a task to re-design IP addressing for 2 sites. Have these doubts,1. At one site we are extending hosts by changing the mask from /24 to /23 for class A ip adress.What all things i need to keep in mind when i change the mask on the router, t...
Hi,We have our office in a multi-storeyed IT campus with other companies in the vicinity. We are planning to go wireless in whole office (full 1 floor). Can anything be done to reduce the signal going outside the office area to prevent attacks/hacks?...
Hi, I need help in understanding the completed steps involved in an office move from one location to other.1. Service provider will provide last mile connectivity to the new office.2. LAN cabling will be done by 3rd party vendor3. New cisco equipment...
In the serial interface we have applied the following Qos:!Interface serial 0/0random-detect dscp-basedservice-policy output WAN-SERIAL!policy-map WAN-SERIAL class class-default shape average 487000 service-policy WAN-OUT!Policy-map WAN-OUTclass...
our company is upgrading to full T1 links from existing 512/1024 capacity. i will work with service provider and make the changes at same time in a conference call. i have a few doubts:interface Serial0/0 bandwidth 1024 ip address 10.x.y.z ip pim spa...
If you are upgrading it remotely, you can enter these commands once the ios is deleted:1. To Boot over the network(from a device thats near to the router)#boot system tftp ios_image ip addressSo that if the router gets switched off for any reason, it...
I do not think there should be any problems... Cisco 2800 series supports the 4HWIC hardware connectivity and it can be used for multilink.you can also check this:http://www.cisco.com/cdc_content_elements/flash/nextgen/webversion/2800/kaon/2801/index...
Is it possible for you to take out the flash card and put in another router that also has external flash slots. Delete all the 10 images and upload a new 2800 image. Put it back to your old router and then try?
