About asgerhartmann

asgerhartmann · 01-31-2022

Having 2 pcs FTD 1120 setup. Internet traffic is working.FTDs can ping each others outside port ok. From client behind FTDs ping also works to other end FTD.Site to sit VPN however does not want to cooperate :).Having setup ikev1, ipsec params etc - ...

asgerhartmann · 12-09-2021

We are experiencing an issue with iphones running ios15.After 10 minutes of idle (screen off) heartbeat through VPN stops working. Seems like ios forces Anyconnect to sleep.Was not an issue in ios14.Anyone else experiencing this - and may have an exp...

asgerhartmann · 01-23-2012

Hello,looking for help on a NAT problem.I have a 1841 deployed as my NAT device towards internet. NAT is setup so that internal addresses can access WWW. I also have some NAT translations opening speciic ports from outside to inside in the form: ip n...

asgerhartmann · 04-07-2011

Having a 1841 with two interfaces. I need to set up NAT with a range of ports. I already have inside interface and outside interface configured plus i have various static NAT entries with syntax e.g.:ip nat inside source static 192.168.200.10 4443 87...

asgerhartmann · 11-03-2010

Having a project to deploy multiple network components which rely on a 1 pulse per second sync signal. The components are connected already in a 1841 based multicast network. Do the 1841's offer the chance to act as IEEE1588 transport mechanism?

asgerhartmann · 02-01-2022

Things are pinging now. Access lists made the trick at the end. Thx mate for the extensive help given.

asgerhartmann · 01-31-2022

Checked now with PING from PC behind FTD - to PC behind other FTD. Ping does not arrive on receiver PC (also not seen on Wireshark). On both FTD, IKE SA and IPSEC SA are up - and the IPSEC SA shows encapsulated packets incrementing with the ping pack...

asgerhartmann · 01-31-2022

@Rob Ingram not even the IKEv1 has any SA - so the units do not even authenticate. Do i make a NAT rule on outside interface mapping orignal src and dst to translated src and dst?

asgerhartmann · 07-01-2020

Hi Richard, i found the issue. Everywhere i looked - the speed mentioed on the port is 9600. By just trying - i found that 115200 actually works. In the doc you linked - it is mentioned that on "earlier models" it was 115200. I just bought mine! Than...

asgerhartmann · 06-30-2020

Hi Guiseppe, i am having trouble connecting to the USB console of the IR 1101 router.My PC has the correct drivers downloaded/installed (Silicon Labs CP210x USB to UART bridge) and when i attach the cable to the IR1101, the PC assigns COM6 to the con...

Member Since	‎11-03-2010 04:02 AM
Date Last Visited	‎10-05-2022 12:31 AM
Posts	22

User Statistics

User Activity

FTD site to site VPN

Cisco Anyconnect and Apple ios 15

Access to WEB server on outside address from LAN

NAT with port range

Does Cisco 1841 support IEEE 1588 PTP protocol?

Re: FTD site to site VPN

Re: FTD site to site VPN

Re: FTD site to site VPN

Re: Connect to Cisco IR11101 Industrial Integrated Services Router

Re: Connect to Cisco IR11101 Industrial Integrated Services Router