When I enter the command: clear module contentSwitchingModule 2 counters the value: Connections Current: 30713 does not reset. What I have to do to reset this value, is it normal that it does not reset?
Hi I have a router 1750 with an analog phone connected through an FXS port on the router. The voice works but when the extension number is dialed the phone does not ring. What can the problem be?Regards.
Hi I want to know if a 4503 with Sup II plus TS can be used for the following:* multicast routing* pim-sm* msdp* ipv6 multicast routingThe platform can not use different IOS features than IP BASE so I can not change it to advanced ip services.What ca...
Hi Pete, this is the output of the command:CSUIORTP02#sh module Mod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ ----------- 1 48 48 port 10/100/1000...
Hi, I have another question, Supervisor IV does not work for this? Also, with IP BASE SSH IOS can I supprt these features or I need the ENTERPRISE SERVICES IOS?
That's true I tried to use it as ISDN PRI, but during the lab test we have done these days we also tried to use it as E1 data only and the same message was displayed.Regards.