Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day; Need help seeing what I am not seeing at the moment. I have built a l2l to the AWS cloud I run a packet trace outbound and that passes but when I run packet tracer outbound in I keep getting denied by Implicit rule. I have gone over my con...
Good day I have a ASA 5520 that has a L2L connection to a Palo Alto firewall the user on the PA side is saying that in his logs he sees the connection rekeying every so often. I check my logs and I think this is what he is talking about:May 02 2019...
Good day I have a ASA 5520 and currently I have the following set up access-list OUTSIDE-INBOUND line 15 extended permit tcp any host 10.0.0.22 eq www access-list OUTSIDE-INBOUND line 16 extended permit tcp any host 10.0.0.22 eq https access-list OU...
I am trying to verify that my traffic is hitting the correct interface and going out but the output doesn't seem right to me.
Source: 10.97.10.32
Destination 52.49.24.30
ip route 52.49.24.30 255.255.255.255 89.202.127.77
access-list 199 permit ip h...
Good day;
I have read all the post or at least I think I did but I tried all the suggestion and I still cannot ping across.
In one post it says to try running packet tracer so I did and found out that an ACL is blocking my traffic
but I doubled che...
on more things I this I made a few updates I changed no access-list OUTSIDE_cryptomap_10 extended permit ip object-group Amazon.LocalLDN object-group Amazon-RemoteLDNno access-list OUTSIDE_cryptomap_10 extended permit ip object-group Amazon-RemoteLDN...
Apologies I should of tested this before posting but I took and existing connection into AWS that is working and did the same packet tracer and it failed. So I went back and checked the new tunnel and I can see phase 1 and 2 complete. I can see enc...
Thank you all for your help but I have fixed the issue, anyone else that has this issue here is the fix:This only pertains to ASA running version PRE-9.7 and in my case I am connecting to a Palo Alto so not sure if this is specific to Palo Alto only ...
Hi MarvinYes you cannot just replace the fan module you have to replace the whole switch and once you get the new switch you have to transfer over the licences from the old MDS to the new one. Also you are correct we can no longer open up a service ...
