Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
when i apply this, nothing works. i have 3 vlans and i want vlan 100 and 101 to talk to each other but vlan 102 to not talk to the other two. and i just dont know where to begin. i jsut get very turned around on these these things VLAN100 192.168....
in my example here, what i have in my extended access list is what i want. so there is no need for the VACL. what am I missing? I feel like if I proceed with this and have the explicit deny at the end, then i need to create a long extended list to...
On a 5520 WLCwhen i create a wlan, i have to assign it to an interface. when i create an AP group, then add a wlan to it, I have the ability to assign an interface here was well. the note on it reads below, but doesn't really apply since i am no us...
I cannot find anything quite like what I am describing in the forums or elsewhere so forgive me if this is old or there is a solution available, I could not find that. I have configured a web login page, see attached for config.For security, Layer 2 ...
I have a switch that has several devices on it. these devices are in 4 different vlans. I went to move a cisco wireless access point into a different vlan, a vlan that no end device was currently on. when i did, it said the vlan did not exist on t...
The DNS is optional, so I have not done it yet. I also don't mind not doing the certificate. so i changed the ip address, as I believe that my issue resides with 1.1.1.1 being an issue within browsers such as chrom, firefox, and IE because it was a...
I appreciate the quick follow up. however, I just looked upstream on the network and found another switch in transparent mode. it shouldve been passing the vlans, but for some reason it wasnt. switching it to client mode made the AP come back. it...
by client identifier i assume you mean the name of the dhcp pool? I do have one yes, but did not have to enter that on other bindings that I have cleared. even when using the question mark for help on commands, no command asked for it, so i would b...
This looks good. unfortunately i have catalyst 2960 switches running on ios 12.2(55)SE5
This version of the ios supports eem, but only for the 3750 and 3560 switches, not the 2960 switches. i am going to try anyways. thank you very much...
so i...
