Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an issue where the 1131 AP seems like it is connecting to the 4402 controller, but about 2 minutes later, it is disconnected. Here is the last few lines of my debug output. This happens to all APs. Controller is running 3.2.150.10. 113...
I have a 2811 router that I would like to configure as a term server. There is a module installed that is labeled ASYNC 16A. I've tried this configuration, but I seem to be missing something. Does anyone have a sample config that will work? Thank...
I was wondering if it would be possible to disable or change the DoS settings on the CSS. At the moment, it is flagging valid hosts for a SYN attack and I'd like to either change the definition of "SYN attack" to a higher count than 10 packets or di...
GP, I entered the command "line 66 81" and configured the lines at the same time. I connected the first 4 ports to the console ports on various cisco equipment, but it's still not working. When I use the "connect" command to access the other device...
Router(config)#line ? <0-326> First Line number aux Auxiliary line console Primary terminal line tty Terminal controller vty Virtual terminal x/y Slot/Port for Modems x/y/z Slot/Subslot/Port for Modems
Here's some more info. This is the output from the "show lines" command. Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int* 0 0 CTY - - - - - 0 0 0/0 - 1 1 AUX 96...
