Hi @Cybrid Group . You can use the Import/Export feature to copy configurations between appliances. For more information, you can check the following Firepower Management Center Configuration Guide - Configuration Import and Export. There are some li...

Hi @mkoli . If I understood your request correctly, what you are looking for is a feature called "Change reconciliation" in FMC. You can read more about it in this configuration guide Firepower Management Center Configuration Guide - Change Reconcili...

Hi @phil96564 . Can you please provide more details on how you configured the NAT rule?Also, can you please provide a networking scheme (a picture or whatever) to understand better the scenario? Thanks. Luca

Hi @AlexandreMoniot. As I understand, you have a similar configuration as the one shown in the Firepower Management Center Device Configuration Guide, 7.1 - Chapter: ECMP :   If you followed the configuration provided in the guide: "R3, follows R4>R...

Good morning @BastiiGee . Can you please give more details on the topology (what interfaces are connected to what, how they are configured, etc..). Also, remember that for the traffic to be logged and seen in the connection events, you must enable lo...