Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have some doubts about a work i have to make in the next few days and I'm not very fond in remote access. I will have to configure a Cisco 800 on a remote side (it`s an employee's house). The central site is already configured. The scenario is so...
HiWe are implementing OSPF authentication in our network, and by the moment we are doing fine in the areas surrounding area 0. These are small areas (5 to 9 routers in each of them), and all joined together with E1s (serial interfaces). Touching the ...
HiI would like to know if it's possible to kill or clear a process that's stuck in catOS. We had a problem of this kind last week, and we was trying to find a way to clear those "dead" processes without having to reboot the supervisor or the entire s...
HiI'm doing a report on a HDLC line that failed somes days ago, and seeing the logs doesn't give me details about which side caused the problem. Is there a way to figure out where the problem started (which side) if you don't have more information ab...
HiAnother group just brought me a Catalyst 6513 with Supervisor 720 with MSFC3. Teh problem I have is they made some kind of configuration on the console line and when I try to connecto through th console port, I recieve a prompt saying something lik...
I have been investigating and maybe the solution would be creating a ATM interface and apply there my public IP address along with the vpi/vci configuration, and also the crypt map. I think it will be enough with that and the IPSec/IKE configuration ...
Yes, I also think it's a bit tricky and maybe a waste of time. I will try it in the only to see "what happens" and I'll post here the results. By now, I think the best choice is upgrading the routers that have version 11.x. Thanks to both of you, Edi...
HiI'v been thinking about another possibility that maybe isn't suitable, or simply not viable at all. We have ospf process 1 in out area 0 network. Couldn't it be possible to create a second process, for example process 2, and put there the authentic...
Hi, thanks for the repliesWe thought about that some time ago, but the problem is that many devices have versions beneath the 12.0, and they don't support interface authentication. Here is a excerpt from a Cisco document:"Q. Which Cisco IOS Software ...
HiWe hace seen that while inserting the password in interface mode, there's not going to be any problem, but the issue will be starting to ingress the authentication command in "router ospf x". Then, it will start to activate ospf in that router/MSFC...
