About Mansoor Ahmed

Mansoor Ahmed · 08-13-2015

H iGuys,I'm interested to know if there is a way to setup a point to point bridge between two buildings (porta cabins) using a couple of Cisco CAP2702I Access points. As these APs are lightweight, I am using a 5508 WLC to manage these APs. I have a c...

Mansoor Ahmed · 01-20-2015

Hi,We have a situation on our LAN where some clients are receiving DNS information from a rogue network device. We have been able to trace the device but we cannot turn off the DHCP feature on it as we do not have administrative control on this devic...

Mansoor Ahmed · 08-18-2015

Thank you Marc, I had a look at the doc and it seems it should address my requirement, thank you.

Mansoor Ahmed · 01-20-2015

Hi Aaron,Thank you for your input. So you mean to say I don't need to mark any port as trusted and it will still work? As for the rogue DHCP, it seems to be coming from the WiMAX backup device that is installed by our ISP (this is a remote site that ...

Mansoor Ahmed · 10-18-2011

I was looking into the same command and I was facing the same problem. Apparently, the ping command is classified under the category "terminated using keystroke".I found the solution in the new RTR command and it serves the purpose well. Below is wh...

Member Since	‎08-17-2010 12:20 AM
Date Last Visited	‎10-09-2017 01:38 PM
Posts	9

User Statistics

User Activity

Point to Point bridge with CAP2702I

DHCP snooping for Cisco built-in DHCP server?

Thank you Marc, I had a look

Hi Aaron,Thank you for your

kron with "cli ping"