All - we are about to install a new UC on UCS solution. UCS220M3 server with CUCM 9X, CUBAC BE, and Unity Cxn 9X. I am trying to discern the best way to ensure routine system backup.Backup at the ESXI host level (or through other facilities typic...
One additional issue we've run into. We updated our CME to version 7.0 and therefore added new phone firmware. Some of our 7941/7961 phones are not upgrading but quickly error with 'error updating locale' and then proceed to boot with the old firmw...
All-I have a CP-7912G that is not starting when connected to the network. The red/green lights come on, but then nothing else happens. I've done several searches on this forum and through TAC online and have not found any other references/fixes for...
Is it possible to create an announce-only mailbox in CUE 3.0?We need a box that plays a custom greeting but does NOT offer to accept an incoming message. We tried setting messagesize 0 but that's out of range.Ideas/Suggestions?
All -I have a Polycom VSX5000e located on an internal segment located behind an ASA5510. I have a static address translation for the video device. When an external video endpoint 'calls' our device (IP/H.323 and not SIP) we get ringing indication, ...
Thanks for your input. Apparently, a little sleep helped tremendously. Simple plar is exactly what we were dealing with, but I still had to get an offhook status internally to match to an outbound dial-peer...It was the outbound dial peers that w...
Ok.. so the error updated locale isn't an issue. Then I guess the bigger question is why aren't some of them updating to the new firmware. The locale error seemed to be the only connecting thread between those that would not download the update, an...
I concur. The two are not compatible when you expect to transit VLANs between them. That gem of constraint I finally found in the 1300-series configuration documentation.Here's the link: http://www.cisco.com/en/US/docs/wireless/access_point/1300/1...
Exchange 2007 support is begins in Unity 5.x and higher. An upgrade to Unity 5,x will need to be performed first (as it supports Exchange 2000, 2003, 2007)...then migrate the exchange cluster to 2007.
