Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
<p>I have a voice gw, that started pushing this error message, but then the config of my PRI port was changed, no one changed it. It rebooted and booted up with a different config on the port. </p><p>This was the changed config:</p><p>interface Seri...
I did some basic snmp monitoring to see what my utilization is on some routers. I would like to be able to break that down by the type of traffic, in high utilization spots. (just the wan links) If I do a#ip flow-cache timeout active 1#ip cef#ip flo...
I have 2 t1's from 2 different providers connecting 2 different 1700 series routers.I can't really do BGP here, but what would be the best way to connect the secondary internet connection up to an ASA.If I could have one connection for VPN and one fo...
I have a 2000 server that offers MRI images to remote clients. From this site I have a vpn useing a pix at the remote.Telnet, Ping, and http works, sending images does not, I suspect this is an MTU issue, do I need to change the MTU at both the host...
I have a pix 501, with vpn users authenticating off of MS 2000 IAS. Works great although I want to filter a few users to only be able access a couple PC's when they come in through the pix.I created a new group on NT called Vendors, added the users ...
I have TAC involved they mentioned something called UC520 bug but have to talk to the developer. They recomended I change my IOS which is fine, although I have lost confidence in this router.This router has been just doing data for the network for ...
IP CEF kills the connection!Just a heads up if someone reads this post, luckily I tested it, when you turn on IP cef it killed my pings.Is there anyway to turn on Netflow monitoring without bringing anything down?
Does enabling ip route-cache flow, have any effect on the routing or current connections when I turn it on. Basically is it safe to turn on without worry, like snmp?
I was going to use two 1700's for the internet and two outside interfaces on the asa. Although it looks like I am going to have to use 1 1700 with 2 ts.Then use policy routing.I hate nating before the fw though, anyother ideas?
Host=2000 Server - Netcreen MTUs are default accrossClient=Unix based MRI machine -Cisco PIXThe MRI machine sends images to the the 2000 server on port 7777. Again telnet,ping,email, all work. Its just sending the images which I think may have som...
