Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I need your support on a routing and siwitching challenge I currently encounter.My setup is the following :-hosts, server -----L3 switch----router.The hosts and the server are in the same subnet. Due to a special DSCP marking which is not sup...
Hi guys,I'm trying to find out what is the minimum downtime for a Cisco 2800 series LAN interface configured as DHCP client, in order to initiate a new DHCP discover.How much time does it need to take for the Cisco to "sense" the phy disconnection ?A...
Hi Guys,I hope I can get support on the following issue. I have the following config on a router 1811 :interface FastEthernet1 ip address 192.168.161.1 255.255.255.0 secondary ip address 192.168.163.1 255.255.255.0 secondary ip address 192.168.164.1 ...
I have the following config running on 1800 series router :!bridge irbbridge 1 priority 0bridge 1 protocol ieeebridge 1 route ipbridge 1 aging-time 60interface BVI1 mac-address 001c.5817.6431 ip address 2.2.2.10 255.255.255.0 no ip redirects ip local...
Hi,I am trying to achieve to following scenario. Basically I have Q-in-Q with DSCP tagged - vlans which I am trying to map to specific inner vlans, trying to eliminate as much as possible the subinterfaces burden.Any piece of advice- what types of ro...
Hi,I need to test a scenario where SOHO cisco routers are used, and I need to know if this configuration is changeable or at list visible in the config.I assume the SOHO routers have the settings alligned with other ones..
Hi Alain,Thanks for the prompt reply.Since I am able to manipulate the config without any risk (this router is working in a testing lab now), I could easily remove ip nat inside source static 10.11.12.30 192.168.160.1.Immediately after changing this ...
