Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Alright I'm at my wits end. I need some help configuring a basic WLC setup but from distribution switch 1 to access switch 1 where the WLC makes two hops to get to the Lightweight access point it is supposed to manage. My issue is that I CAN ping the...
Let me start by saying this is for my homelab and I bought the 3502i off of ebay, i'm trying to factory reset it for use in my personal networking setup for study.As a premise, I've never had issues with my Cisco 3750-x, 3850, or Juniper srx320 secu...
Hi, I am currently learning for the CCNA by creating my own networks on packet tracer, I thought BPDUs with a dominant priority being received by root bridges meant that it would turnover the responsibility of being the root bridge to the advertised ...
Hello, I'm currently studying for the CCNA and I took to packet tracer to make some of my own network maps, however, I seem to be missing some core idea with STP as the more complicated my networks get, the more latency and outright dropping of packe...
Alright, so I found the solution for my guests WLAN. All I needed to do was describe option 43 in hex instead of by an ip address. I guess not all APs can translate an ip address readily from option 43, that's my assumption but hex seems to be the wa...
Note: The following top section of reading may not be necessary, I think I narrowed it down beneath in this posts' 10/30/2023 EDIT: section. i'm not deleting the top section to keep the notes orderly for future reference in case anyone has similar is...
First, thanks for taking the time to reply, I'm greatly appreciative, next for the sake of simplicity I will first go through your questions, line-by-line, then add any relevant information. Q: I think I can summarise your issue as:Your 2504 WLC cann...
Alright, I'll give it a try, I've pretty much exhausted every other possibility and that's the last thing I haven't tried, cable coming in tomorrow, FTDI usb to serial rj45, hopefully that's it and I can finally get these APs up and running.
