About zeljkosan

zeljkosan · 12-16-2024

Hello team, I have one smaller issue (at least I think that) in IPSec tunnel between ASA 5585 (9.12(4)67) and Firepower 2110 (do not know version, but it is 7.0.0+) So tunnel is up, and first phase is ok. But we get constant complains about traffic ...

zeljkosan · 10-30-2024

Hello guys, there is one problem with our client who uses identically ASA 5545-X. So we have 2 ASA: primary/active 9.8(4)25 secondary/standby 9.12(4) - which I upgraded while it was in standby mode Getting warnings on primary/active: ************WAR...

FMC configure FTD users · 08-19-2024

Hello team, so far I have been asking here for help before TAC, and it was always helpful, or I get perfect hint. This time, I have problem with 2 FTD managed by FMC. Situation is next. We have installed FMC at client place (version 7.0.1 , yes I kn...

zeljkosan · 07-10-2024

Hello team, recently our client send us a question about software for end of all device. We suggested new device, but it is working properly, so they refuse. Does anyone have this: AIR-CT5500-AP_BUNDLE-K9-8-5-182-0.aes Thanks, br.

zeljkosan · 05-27-2024

Hello team, I have some weird notification on WS-C2960G-8TC-L. Our monitoring system is sending us: Memory on "Main (Processor)" is high! Alert: Memory on "Main (Processor)" is high! - Current: 80 %, Threshold: 80% Status: OK Severity: Major But wh...

zeljkosan · 12-16-2024

Hello , ASA is doing NAT, but we have static public IP. Rob, will check with other side with Firepower device

zeljkosan · 12-16-2024

Hello, crypto ikev2 policy 7encryption aes-256 aesintegrity sha256 shaprf sha256 shalifetime seconds 86400 Our side is ASA 5585, on their Firepower 2110 with FTD. Generally, I have issues that they constantly complain that is on our side (ASA 5585) p...

zeljkosan · 12-16-2024

Hello team, thanks for assist. Aref, I have fixed with your method.

zeljkosan · 11-05-2024

Hello team, these ''HELLO'' was during reboot. Regarding That tells us the service module (Firepower) on the secondary standby is failed. Either fix that or remove monitoring for it with "no monitor-interface service-module". ASA-SFR module on stan...

zeljkosan · 11-05-2024

Hello team, thanks for the tips, so far still not managing trouble issue. I have attach commands: show failover state show failover history show run failover

Member Since	‎02-22-2023 02:14 AM
Date Last Visited	‎12-17-2024 12:11 AM
Posts	22
Total Helpful Votes Received	6

User Statistics

User Activity

Cisco ASA and Firepower IPSec tunnel

ASA-5545X change active/standby with different ASA version

FMC configure FTD users

WLC controller AIR CT5500 AP

Cisco WS-C2960G-8TC-L Memory on "Main (Processor)" is high

Re: Cisco ASA and Firepower IPSec tunnel

Re: Cisco ASA and Firepower IPSec tunnel

Re: ASA-5545X change active/standby with different ASA version

Re: ASA-5545X change active/standby with different ASA version

Re: ASA-5545X change active/standby with different ASA version