Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to do dot1q trunking between two 1242's that are bridging back to back? We need to connect a remote building and have multiple vlans's trunked via a wireless solution. We were also wondering if we could do this using the remote 1242 ...
Looking for the command to use the loopback address as the network ID for ACS. Is there a command you can configure on the switch/router to do this? Currently we fail authentication based off the p2p address connecting the device.
Can anyone tell me why I might see a device as unconnected in Topology Services > Network Views > Unconnected Devices. I know CDP has to be enabled, the devices are reachable, and has neighbors. Is there any other critera that has to be met? Everyt...
I'm having the same issue. My server guys came to me last week wanting to impliment this to patch systems. So my question to you is, what do you mean by your question? Is there a "default address" parameter I need to ask the server guys about? An...
Ok, so I'm pretty sure we have this configured according to the documentation @ http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml#vlanbr, but it's still not working. I realize this is 1300 se...
Thanks, but I need the trunk to run across the wireless aspect of the design. I did find a link under the 1300 series that diagrams this solution, so I have found the answer, now I just need to get it to work.
