Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello and sorry for my english,How i can find if my routeur C8300-2N2S-4T2X support LACP etherchannel ?(IOS : Cisco IOS XE Software, Version 17.09.03a)thanks a lot
Hello and sorry for my bad english,I have a lag/etherchannel between my Cisco C3850 and two Aruba 8100 in stack. I have troubles because there is a lot of packets discarded as you can see below on picture. My configuration on Cisco is like this :inte...
Hello and sorry for my english , My core switch is also root of spanning-tree, i use Rapid-pvst. On this switch, in global configuration i can see :spanning-tree portfast bpduguard defaultspanning-tree portfast bpdufilter defaultThis commands are ...
Hello and sorry for my english;On interfaces VLAN of my core switch there is this command : ip pim dense-mode and not on all VLAN configuration.Do you think it is necessary ? i have to delete ? interface Vlan30 ...
Hello and sorry for my english,I have all switch connect to Cisco 3850. I have also physicals servers and Wmware.When i ping from servers, physical or not the gateway who is on C3850, the latency is very high, it can be 1ms and next 50ms, next 100ms,...
Hello,It is because twe 2 Aruba is not really a stack but a cluster. One port ofeach Aruba can be in the same lag, but when we pass command to see stats orsomething else, we can see only for the switch where we are connect. Yes inot, not very easy. A...
To be sure, sorry because my english is not so good :On Cisco core, i have in my global configuration this : port-channel load-balance src-dst-macet let this configuration and just in the 2 port-channel, i had : port-channel load-balance src-dst-mixe...
