Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Catalyst 4003 running CatOS version 4.5(2).When I type show module, I get that Switching Supervisor is faulty Switching Supervisor WS-X4012 faultyOther two modules are ok. Why?When I type show system I get the Sys-Status as f...
I want to configure my switch to run snmp v2c, but do not know how to do it(I do not find the exact command).As I understand, by default the switch will use version 1. I configured as following:sw(config)#snmp-server community xxxx roand in my snmp m...
So, as you said, I should reload the switch and see what will show me the sh mod? Is it right? Does the sh test take a lot of overheat on the switch? What command in CatOS give cpu loading on the switch? Thank you.
But I do not find the specified OID. I need to collect via SNMP the CPU and memory load. For that I use MRTG, in mrtg config file I have to specify the OID for CPU usage and memory usage. So, I need the OID for CPU and memory. On these links there ar...
