Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have tried to upgrade the ASA. from 8.0.4 to 8.2 code.I delet the configuration and disko and boot the ASA from TFTP. it boots successfully but when I tried to configure IP address on any interface the IP address command is not there.I tried...
"CM0060 PRIMARY RUNNING Config fetch SUCCESS forwsd15231.netiss.intesabci.net, version number 3archived.CM0057 VLAN RUNNING Config fetch SUCCESS, archivalfailed for wsd15231.netiss.intesabci.net Cause: CM0012:Unable to create new version on archive $...
Hi, I got my PIX down with UR license I asked my vendor to repalce the pix btu how can I get the UR license for the new PIX. WHile tere is no RMA raised to cisco.Kindly help me in the procedure to get the new license without opening a TAC case with C...
Dear I have a FWSM with 11 context and VMS security monitor is collecting logs.The default reports and events we can see.BUt we need to see the reports per context . KIndly tell me how to customize the security monitor reports tab.
Could you tell me more. As I have already browsed the CCO. We run CiscoWorks LMS 2.5.1 and CiscoView v6.1. I have seen this info on the web however I cannot believe that Cisco has not added support of ASA5520 or ASA5510 toCiscoWorks. AT this point I ...
Can you tell me the version of running PIX?**If it is 7.0.2, it is a known bug.** You can try this by stoping the http inspection.** If it works fine plz upgrade your pix to 7.0.4 Version.
Dear Martin,Thanks for your response. I have PIX with 7.0.4 version and 2 ISP links.I have VPN connectivity between 2 offices over IPSEC.My US office is stable but India end links fluctuate so in India I have 2 ISP and required to make them redundant...
