Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using 2611 as voice gateway with VIC-2FXS. Phone - 2611 ---IP network--- 5350 --PRI-- ISDN SWITCHBecause the ISDN switch don't send the in-band ringback and Progress Indicator to the 5350, so I want to generate the ringback on the Cisco Voice ga...
As I can see, The VACL feature is supported in the latest native IOS for SUP1/MSFC2 & SUP2/MSFC2. But can the latest IOS for SUP1/MSFC1 support this feature? ThanskRegardsJeffrey
Now the catalyst switches and routers can only support the FEC load balancing methods based on dst-ip,dst-mac,src-dst-mac,src-ip,src-mac. The MPLS label based load balancing methods only support in SUP-720. So If the customer want to use the FEC and ...
If a Cisco IOS router will adjust its interface MTU when the tag swtiching is enabled on it? if it do, what is the Maximum MTU value can the interface pass?
Instead of routing your international calls to your 1760V gateway, you can config the ccm to route your international calls to the remote gateway which is used to terminate your international calls
The coutners in show interface have included the packets loss of all the data including voice, so I want to find out how I can find the packet loss for voice only. It seems the show active voice command should have these parameters, but I don't know ...
My question is base on the native IOS for the SUP1/MSFC1, but i can not find the document for the latest native IOS for SUP1/MSFC1 can support the VACL.
Maximun label stack is 5 so 5*4=20byes? (i think eack label is 4-byte length)Through my lab, I found something. First, the IOS may change the actual tag mtu value according to your "tag-switching mtu , in my lab, when I configured "tag-switching mtu ...
But are there any figures that can be used as reference to justify if the router is in the normal status. For example, under some pre-defined conditions and on some platforms, how many active NAT translation sessions and how many pps can be supported...
