Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are currently running a Cisco 9800-CL controller on VMware and are planning to migrate it to Azure. We already have an existing license and would like to understand how the licensing will be handled during the migration.Since both controllers m...
Hi Everyone,
We have 5 access points deployed on each of Floor A and Floor B. The requirement is to block a specific client MAC address on Floor A, while allowing the same client to connect normally on Floor B.
The WLAN is centrally switched using a ...
Hi team,
In my environment, I've noticed an anomaly with our 500 APs. Around 450 of them are establishing CAPWAP tunnels with 1485 MTU, while the remaining 50 are using 1005 MTU.
AP Model: 9166 {All APs are in local mode}
WLC: 9800
is it any bu...
Hi all,
I am from india.I am facing issue in AP 9166I-ROW-6E model ap not joining to C9800 WLC (Country Code - IN)
I want to know that is this AP supported in India ?
If not should i change the WLC country code to US. it is fine with Cisco regulat...
Hi all,
I am going to upgrade my mobility express step up ( Air-2800) to 9800 WLC.
I am facing a challange where all my APs are configured with static IP and WLC IP , Now we are changing Managemnet subnet where the new 9800 will be placed.is there an...
Cisco licensing can be a bit difficult to understand.@aleabrahao @MHM Cisco World – We have approximately 400 Access Points in different locations, so we cannot migrate all APs at once. The migration will need to be completed in phases.Please correct...
