Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I ran out of idea with this problem I have, I used to able to snmpwalk the full MIB tree on my Cisco 2500 wireless controller but I no longer can after a reboot on it WLC. I believe all the configs are fine, no error on snmp neither. I am abl...
No it didn't work, I didn't change anything because my configs look correct comparing to your link.
I begin to think it is a bug, may be it isn't a config issue at all? Is there a setting to stop snmpwalk to read the full MIB tree on the wireles...
Hi Balaji,
Thanks for the fast respond and advice, I have checked through the settings from your link you sent up to the SNMPv3 part as we don't use it. Is it compulsory to put some config there even though it isn't enabled? Funny enough, my sn...
