Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking to reconfigure a few hundred Meraki Network sites with new Radius servers. I am aware how to configure the new servers themselves, and how to configure the Radius within the wireless configuration. However I am struggling to see a means ...
I am running ISE 3.4 Patch 4 I have a condition that says
If RESTEntraIDStore: External Groups Equals "MyEntraSecurityGroup" Permit access
I know this should be possible from Patch 4 or 3.5 onwards.The device is definitely in the Entra Group, For th...
I recently performed a swap of an MX, When on the Appliance Status page the device shows "Up To Date", but within the organisation Firmware upgrade page these devices show out of date and an upgrade required.This is equally the same for all devices, ...
Just out of curiosity, have you tried running the packet capture via API? Would be interesting to see if it is a front end issue. Alternatively id be asking the question how busy is the AP in question, an unfiltered packet capture could be quite reso...
Always agree with @bigevilbeard and his devnet handbook is well worth it. As far as a meraki lab is concerned you can alway create your own meraki account at https://dashboard.meraki.com From there create your API key and interact with many of the AP...
Thank you Green man, I understand. and appreciate the response. But The question isnt focussed around the MX64It is focuessed around the fact that the Device dashboard says one thing, But the Org Firmware updates page says another. If it is the fact ...
This is correct, I have been able to upgrade the 85 but not the 64. That however was besides my point. The device dashboard and the Organisation Firmware dashboard arent synced up.
