Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
can someone help me understand what i'm missing? my company has an ha pair of C9800-CL-K9 that established capwap tunnels with 61 AIR-AP3802I-B-K9 access points. however, this same C9800-CL-K9 gave an "unexpected dtls version" error ("last disconnect...
the upgrade of my standalone 3850 from iosxe 16.12.13 to 16.12.15 was going ok (install add file flash:cat3k_caa-universalk9.16.12.15.SPA.bin activate commit) until my finger slipped at the 'This operation may require a reload of the system. Do you w...
I converted my 3802i lightweight access point into an autonomous one running 8.5.182, gave it a management ip address of 10.136.32.50 and then rebooted it. but the console message gave a different ip address (same network but not the one I statically...
i'm sorry if this question sounds silly but say at a small branch location I connect port 47 on an access switch to port 1 on a core switch and then repeat with ports 48 & 1 but for some reason each connection is assigned to a different port channel....
I’m sorry for the length of this description but…. I have to replace a standalone c4507r+e (core) switch with a standalone c9407 switch at one of my company’s branch locations. So far the 9407 was powered up and connected to the 4507 via an lacp trun...
understood. since my 3802s can get an ip address i just have to follow the instructions in "Upgrade using archive download-sw" section of https://www.cisco.com/c/en/us/support/docs/wireless/wireless-lan-controller-software/221869-safely-upgrade-acces...
how about these? i got the trace debug from the v9800 wlc and the sh tech from the 3802's console. but they are the same in the sense that the only time 'dtls' is mentioned is for "setup", "teardown", and "Received packet caused DTLS to close connect...
hi Aleabrahao,i think this is the section of sh ver you wanted to see. but an rma might be the only fix? Cisco AP Software, (ap3g3), [cheetah-build:/local/build/JENKINS/workspace/8.2MR4-barbados-cco]Technical Support: http://www.cisco.com/techsupport...
