Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, does anyone know if this will affect the Catalyst 9000 series in the near future?Cisco IOS XE Bundle Boot Mode Will Be Discontinued After Release 27.01 – Product Bulletin
Hello everyone.What's your experience with xFSU upgrades? I know this feature is there for a while, but I don't know anyone that actually used in production.We are planning to upgrade a stack of C9300-48UXM, from 17.12.03 to 17.12.06.We can do it in ...
Hello everyone. I'm trying to make a Regex to match some specific hostnames in one authorization policy, but not managed to do it sucessfully. Here are the conditions, tried witch Matches or Starts With, but no success.Also validated the REGEX with P...
There is no SD WAN in CCNA 1.1 and I bet the new 2.0 will not have it.But what is there? Yes, they add AI.SD WAN is important, but I don't think is worth learning it (or at least try to learn) before mastering routing and switching, for me, this is w...
Hello @ulrich-nguelet-ker HSRP election is happening, since it has the Active / Standby, ensure the switches can ping each others SVI.ping 192.168.45.252 source vlan2352
ping 192.168.45.253 source vlan2352If this works, most probably is a L2 issue, I...
Hello @mdzaf Aggregate = RX + TXSo:500Mbps ingress (LAN/WAN) = 1G aggregate500Mbps egress (LAN/WAN) = 1G aggregateIn total 2G aggregate, so nothing wrong there, you still have the T1, is just how the IOS display you that information. If you still not...
Hello @mdzaf,Could you please share the entire output of the show platform hardware throughput crypto.You can also try to reconfigure the tier-based throughput but this will require a reload.Entitled throughput & throttling in >= 17.14.1a
With HSECK...
Hello @clive.hodgetts.I don't think that will work because even with StackWise Virtual the data plane still distributed per chassis. So you have two options, configure SPAN in both switches or ERSPAN.