Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been using Cisco 3800 series switch and backup interface commands (flex links).switchport backup interface <interface-id> to designate a standby port to define failover behavior. I am replacing these switches with 9300 series, and the previous...
In my environment, I have RD Gateway setup behind the firewall, and it does not have the Internet connection. In this case what are my best options to enable 2FA. I can facilitate SMTP from RD Gateway to mail server on corporate LAN and allow the req...
I have 9200 switch with endpoints connected to it. One particular port is frequently going up and down. [Line protocol changes state to up / down]. This port is connected to a PC. How can I identify the root cause of this failure? It's not related to...
I have FTD2110 in HA as active standby pair using FDM. I am testing HA with failure scenarios, cable failure works perfectly fine. Now I rebooted active firewall (FW-A), standby firewall (FW-B) took over.FW-A reboot took almost 25 minutes, still neve...
I am managing FTD from FDM and I am looking for options where I need to disable a few access rules. Is there any option to disable the rules before deleting them?
