Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIm trying to configure a VPN lan-to-lan in 2 locations.but this VPN Tunnel is not working, these are the details of the VPN Tunelcrypto map: Transform-Set 3des, sha, group2, lifetime 3600,the peer, and an access-list (host-to-host)isakmp pre-share,...
HelloSorry for my poor englishDoes anybody know or have information about this error log or the cause for this issue or in what side is the problem (Source or destination)?172.16.70.10 (Source)10.24.1.26 (Destination)IPSEC(sw_esp_decap): fail antirep...
Hi, i need help, im trying to configure NAT for both directions (Source address an Destination Address).I have 4 Networks.Network A 172.16.25.0IP ADDRESS NAT INSIDE B 172.16.111.124 OVERLOADIP ADDRESS of the HOST C 172.16.18.22IP ADDRESS NAT OUTSIDE ...
i have a problem, in the ip phones 7940/7960`s display appears a error "http error [500]!", and also the ip phones become very slow,that occurs when they go to srst,and come back to CCM server. anyone knows what is the reason??
i have the same issue but with a PIX 515e and a microsoft w2003 CA, i have the certificate in my vpn client but when i am trying to connect to the vpn i get the same error. 17:38:26.562 11/13/07 Sev=Warning/3 IKE/0xA3000068Received un-encrypted ISA...
you can put your callmanager and VGs in the cisco-voice vlan, you can do this in the url http://ipaddressswtich/exec, this url is to use commands like ios, in configure you can use switchport access vlan (cisco-voice).i hope that this helps you
did you find the solution?, i have the same problem, but the ip phone is a 7912g-a, just if both are in the same vlan, but if i use a 7912 g or 7960 it works. switchport access vlan 2 switchport mode dynamic desirable switchport voice vlan 1 switchpo...
