Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am configuring a Cisco 812G and 881G. the part number is C812G+7-K9 & C881G+7-K9. The IOS version is 15.2 (2r) T.when i get to the cellular interface i am not able to set the encapsulation to be PPP. It only support SLIP. Do have any idea on...
Hi All,I am configuring a Cisco 812G and 881G. the part number is C812G+7-K9 & C881G+7-K9. The IOS version is 15.2 (2r) T.when i get to the cellular interface i am not able to set the encapsulation to be PPP. It only support SLIP. Do have any idea on...
Hi All,I have configured a site to site VPN with a cisco ASA 5510.I was able to setup the VPN. Phase1 & Phase2 are all up and traffic can pass.What i notice is that from time to time the tunnel goes down and the remote site will have to send a contin...
Dear All,I have a cisco 2800 router configured and working perfectly.Nowadays if fails passing internet traffic and i realised that when i display the runing config it does not show anything. When i dispay the startup config i could see the config.Ev...
Hi,Thanks for the reply.Is there a command to check previously connected users or a command to view them in a log... Anything to identify them???Appreciate your help
Below is the ACLinterface FastEthernet0/0 ip address 213.X.X.X 255.255.255.240 ip nat outside ip access-group 101 in! interface FastEthernet0/1 ip address 192.168.X.X 255.255.255.0 ip nat inside access-list 101 permit tcp any host 213.X.X.Y eq 5101Th...
