About babalao

babalao · 10-21-2025

Hello, We want to have a FTD (with static public IP) and several Cisco routers (with dynamic IP) connected with IPSEC IKEv2 L2L VPNs with different PSKs for each VPN. We dont find on the FTD how to check the receiving ID that the router would send t...

babalao · 09-12-2025

Hello , a doubt about Manual NAT, if I have to configure static PAT, so I allow connection into my web server on dmz from outside for example. I would have configured this: nat (dmz,outside) source static PRIV-IP PUB-IP service TCP443 TCP443 but In o...

babalao · 06-30-2025

Hello, We have an ISE v3.3, authenticating devices with dot1x and MAB. Is there a way on ISE to know the following?: - how many devices are authenticating in total ?- how many devices are authenticating with dot1x?- how many devices are authenticatin...

babalao · 05-24-2025

Hello, We have a lot of IPSEC VPNs L2L using the VTI (interface tunnel , with tunnel mode ipsec ipv4,etc), but always between Cisco routers. Now I have to establish a VPN L2L with another FW vendor (that probably is not going to have a tunnel interfa...

babalao · 04-14-2025

Hello, Is it possible to emulate/run a Cisco Switch in Vmware workstation for example ? I know I can run the router Catalyst 8000v. I would like the same but with a switch. The purpose is to practice and test networks with switches,routers,FWs ,etc. ...

babalao · 11-10-2025

Hello Rob. do you mean I would configure from GUI with de wizard and then edit it via flexconfig or I should configure from scratch with flexconfig? And if the first option, can I edit a already created tunnel-group name? Thank you for the reply.

babalao · 10-23-2025

Hello, please, any ideas on this? Thank you

babalao · 07-03-2025

For instance if you need to know how many devices are authenticating ok ,(and maybe not authenticating ok(failling) on a switch X, what would you do on ISE? What I do today is to ssh to the Switch and do show authentication sessions and I see it ther...

babalao · 07-03-2025

Hello, but this only shows up to 100 records right? I can not see all devices. Thanks

babalao · 06-10-2025

anyone? thanks.

Member Since	‎04-01-2023 05:40 PM
Date Last Visited	‎11-05-2025 04:36 AM
Posts	71
Total Helpful Votes Received	9

User Statistics

User Activity

FTD Dynamic L2L VPNs

ASA - NAT question

ISE - know how many devices are authenticating with dot1x or mab

VPN IPsec between Cisco router and third party FW

Run Cisco Switch (IOS or Nexus)for learning/practice purposes

Re: FTD Dynamic L2L VPNs

Re: FTD Dynamic L2L VPNs

Re: ISE - know how many devices are authenticating with dot1x or mab

Re: ISE - know how many devices are authenticating with dot1x or mab

Re: VPN IPsec between Cisco router and third party FW