Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded a GSS 4480 (not 4490!) to version 1.1(1.1.0). It does seem to work properly, however, I get the following output from the status command:#gss status Cisco GSS - 1.1(1.1.0) - Sustaining Release GSSM - primary [Thu Oct 28 13:30:4...
I can virtually send any traffic with any port to the content engine to be cached through the wccp service-number command.I tried to use that feature to cache SMTP or POP3, however, it does not work.The TCP handshake is redirected to the CE through W...
May I come back to y.lo's message from January this year. He asked for a shutdown or halt command for CEs.There is a possibility to shutdown the NM-CE-BP (network module) with the service-module command form the IOS. There must be something similar i...
HelloWhen implementing QoS on a switch (e.g. 3550, etc), it uses WRR for output scheduling. Let's say, we run QoS on a 3550 gigabit interface. In WRR, the interface gets 4096 buffers to queue frames/packets (can be verified by #show mls qos interface...
Am I missing out on a feature completly? What I need is the following:When a server initiates a conversation with a client, it assigns a session id and sends a cookie or an URL rewrite. The client's response must go back to the same server based on t...
FEX 2248 will be supported in the next release (Cairo) on the Nexus 7000 32-port 10Gig module. Nexus 2232 will follow later. You may expect Cairo to be released in October 2010.
Sorry, I posted the question a bit too early. SGSSM stands for Standby GSSM and the error message warns that the SGSSM cannot take over from the Primary GSSM, because the versions are not compatible (the Standby GSSM still is on version 1.0).Igi
Thanks for your input. I totally agree with you (although still not confirmed) that the queue size set with hold-queue is for FIFO queueing only.Priority queueing is in fact an option on the switches, however, it is not configured through the priorit...
A spanning tree must be consistent throughout the layer 2 topology, that's why you cannot just disable it somewhere. If you did, the probability of running into problems would be very likely.Portfast is what you're looking for. However, portfast stil...
