Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an SM-ES3-24-P switch module that seems to be in a failed state. How can I revive it?#service-module gi 2/0 statusService Module is Cisco GigabitEthernet2/0Service Module supports session via TTY line 131Service Module is failedService Modul...
I am trying to get my HWIC-Cable-D-2 going with my ISP. It syncs up fine, but remains unauthorized. The ISP validates the serial number of "the modem", but I need to know which serial number to send them.From what I see, there are 3 possibilities:R...
Running 15.7(3)M5 on the router. I have reseated, reloaded, oir-stop / oir-start. Nothing seems to work.I have the correct firmware for the module on the router flash, I am trying to find a way to initiate Xmodem transfer, but so far I am unsuccess...
R1 is the cloud The R1 is your ISP router - it's configuration is not relevant (except that the external interfaces of the other routers should be able to reach each other).
