Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks!!I'd like to know if the Cisco 2821 is hot-pluggable device, I want to plug a HWIC-2FE card in this device, is it possible without power down the router?.Thanks in advance!!
Hello folks,I'm trying to implement the example from URL: http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801eafcb.shtmlThe platform and version of HUB device is: Cisco CISCO1941/K9 (revision 1.0) with 491520K/32...
Hello,I have a spoke node of a DMVPN infrastructure. Actually, this spoke has a only WAN (Internet) connection. We want provide with a second line of the same ISP to load balancing and FailOver. Must I use CEF with load balancing per destination or p...
Hello folks,I have a 2821 cisco router with two Gigabyte ethernet interfaces. I have adquired a 2-Port Fast Ethernet Hight-Speed WIC for Cisco Integrated Services Routers. I have followed the instructions to install this slot, I have choosed the 0 sl...
Hello Folks!!I have a problem with a cisco 837. When I connect the device to ADSL line, the CD led is off, the TX and RX leds are blinking. On the ADSL line exist other router that I want to replace with it and this other work fine.Could somebody hel...
The ping only works from spoke to hub, the same thing happen with the routing updates. The spoke advertirse its networks on hub device, but the hub device doesn't it on spoke. Some idea?.Thanks in advance
Hi Ryan,I'm aware of the existence of dual hub - single dmvpn layout and the dual hub - dual dmvpn layout topology, but I don't want to complicate the infraestructure for this moments. The spoke has a WAN interface only, I want to use vlan with subin...
