Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When running sflow on the above mentioned switch and nxos version. I am not seeing an output index.I wrote a python script to receive the raw xdr using xdrlib, struct, and socket. I can see the 2 UINT 32 bit fields for "input interface value" and "ou...
There is a limitation when going from 3.X to 16.3.5 Denali because of the 3.Xe boot loader being unable to boot a file more than 500MB from the flash.I cannot get 3.6.4E to update to Fuji 16.9.8. That OS file is only 429MB so that limitation should n...
I am trying to get EAP Anyconnect working with local authentication based on the following article.https://www.cisco.com/c/en/us/support/docs/security/flexvpn/200555-FlexVPN-AnyConnect-IKEv2-Remote-Access.html I am using IOS-XE 16.9.7 FUJI and Anycon...
I downloaded and installed the 5921 ESR and requested a demo license through the cisco portal. The problem I am having is that there is no way for me to disable the smart license feature?
The command "no license smart enable" does not exist. Withou...
does this relate to the 93180. max-mode l3 cannot be changed but it shows up in show run all as"no system routing max-mode l3"Am I supposed to change the system routing template from the default LPM to something else so I can see sflow egress interfa...
What group address are you trying to use?239.255.255.250 is a plug-n-play mcast group for service discovery like printers, scanners and all of those registering messages are from having the hosts enabled with SSDP service. 224.0.1.40 is auto-rp for e...
Without any configs for the router or the downstream switch it could be the router interface igmp settings, igmp snooping on the downstream switch not working or configured properly, or the host not sending igmp membership to the routers port with th...
It looks like you would do AS Path prepending to control inbound traffic between HE and Cogent.Hurricane Electric looks like it uses communities to set local preference on paths to your network. You will want to contact them to get what communities e...
You will want to be careful about using prefix length to control inbound selection. Any prefix larger than /24 (/48 IPv6) is normally filtered between AS. The /25 or /28 prefixes on the global BGP table are an experiment to check how far a longer tha...
