Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,
Continuing with the previous discussion - https://community.cisco.com/t5/wireless/specific-channels-per-wlan-basis-on-cisco-9800/td-p/4838320
I'm using Cisco 9800-40-K9 WLC and C9115AXI-E APs. I have a requirement where the wifi client ...
Hi,
I'm using Cisco 9800-40 WLC.
I have a requirement where I want a specific SSID (say SSID_A) to broadcast on 5GHz on only some specific channels and not on all channel.
That is because the devices connecting to that SSID_A supports only 5GHz and a...
Hi,
I need to disable redundancy on the active WLC for some reason. However, when I try to apply the config after disabling the redundancy, it gives me a warning saying "Clearing the chassis HA configuration will result in both the chassis move into ...
Hi all,
I have a Cisco nexus N9K-C9372TX stuck in the loader prompt. I have the nxos copied in the bootflash. I have tried 2 options.
First option -
I tried to boot directly from tftp and received the following error:
################################...
@Leo Laohoo You almost guessed it correct. Not ASCOM but Vocera. I think Spectralink is a product of Vocera
Funny part is, these Vocera badges do support dual band wifi and on all channels, but for some reason (not known to me) the Vocera admins ha...
Hi @sp2720401 using the process of bootable USB helped in resolving the issue. We were able to boot an older NXOS 6.X from the USB and format the bootflash. Then we upgraded to NXOS 7.X and now the switch is back in normal mode and working fine.
Hi M02@rt37, the commands "delete" and "meminfo" didn't work/aren't available. See the below output for all the things that were tried -
loader > dir
bootflash::
lost+found
.p...
