About techmaster

techmaster · 03-25-2009

How do I establish static routes (bi-directional) between the VRF and the global table?Cat 650912.2(33)Single VRF, Full BGP. EIGRP inside the VRF.

techmaster · 03-24-2009

cat 6500 with IPSec VPN module. VTI is configured, but debugs show that it is unable to allocate ike sa.Have changed the key, removed the keyring and just used a global type isakmp key. no change. crypto engine mode vrfcrypto keyring key1Â Â pre-shar...

techmaster · 02-13-2008

Does anyone know if WCS can use (as a Spectrum Expert) Fluke's Spectrum Analyzer software (The same OEM as Cognio)?

techmaster · 07-07-2005

I have a PIX with a 2621 between it and three ISP's. I am now terminating a VPN (clients) to the PIX via one of the ISP's. I want to be able to access the same VPN group from any one of the three ISP's, should one or two fail. What is the best way to...

techmaster · 06-23-2009

Did you ever resolve this? How?I have the same error on a 4.2 trial version, using PEAP. EAP-TLS works just fine however. Strange.

techmaster · 02-19-2008

thanks. Please clarify: is that Contact Center Express or Cisco Compatible Extensions, And how do either one of those show me if a spectrum analyzer with interface with WCS (added into the WCS interface as a SA)?I can find no 'page' that has that inf...

techmaster · 05-05-2004

I have not found one, but according to TAC: For EAP-FAST, the ACS must support that also (version 3.2.3). This is the only version that supports EAP-FAST, so there must be a Cisco ACS v 3.2.2 on the network to use EAP-FAST.If anyone can refute this, ...

Member Since	‎10-04-2001 12:11 PM
Date Last Visited	‎01-10-2020 12:13 AM
Posts	9

User Statistics

User Activity

How do I route out of the VRF to the global table

unable to allocate ike sa

WCS 4.2: Will Fluke spectrum Analyzer work with WCS?

VPN to PIX with multiple ISP's

Re: "Authetication session invalidated" via Radius / ACS

Re: WCS 4.2: Will Fluke spectrum Analyzer work with WCS?

Re: Configure EAP-FAST