Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure a routing load-balance with Cisco ACE Module based on the following scenario:local users has a router (R1) as it default gateway, this router (R1) has a default route to the VIP that represent the serverfarm with two linux ser...
Hi guys,Is there anyway to use both "spanning-tree portfast" and "switchport mode trunk" at the same time at the same interface ?I did the config but I did not get the expected result ! As you can see at the configs below, I?ve configured two ports:f...
