Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have one pix in my local LAN. so i have created one zone for servers, and second zone for some users and third zone for some other users. Now i have installed cisco call manger 4.1 and it works fine if phone and ccm are in same zone, but i want ...
HiI have one pix in my local LAN. so i have created one zone for servers, and second zone for some users and third zone for some other users. Now i have installed ccm and it works fine if phone and ccm are in same zone, but i want to put ccm in serve...
HiI have 2 6500 working as core and ospf area 0 running between them. These 2 core switches are connected to each other with a single link. There are 2 4500 distribution switches connected to these 2 cores having 2 links to each of the core. We have ...
HiI have the follwoing networkATM SW1---ATM SW2---ATM SW3---6509--3550there are 3 ATM switches connected in triangle fashion and 6509 is connected to one of the ATM switch through a gigabit port on ATM switch. These ATM switches are not cisco switche...
HiPlease help me out understanding the following1) Purpose of Central forwarding card for WS-67xx module.2) Will WS-X6704-10GE 10 GE module work without it.3) Is CFC comes installed on 10GE module when it is despatched from factory if not pls give me...
HiI managed to resolve this issue anhow. There was a bug in pix, due to which i need to remove "fixup skinny" command from pix, try removing "fixup skinny" and open all ports in pix to test.ReagrdsAshish
HiWe dont have budget right now to buy multilayer image for osfp right now, pls tell me some other alternate, i have heard of object tracking in which i can track line protocol status and route trace.Best Regards
Hi BradThese ASX 1000 switches are not L3 capable and marconi and 6509 is connected thru a switch port and bothe the ports are in vlan1 with the same subnet range, as ASX 1000 is a pure L2 ATM switch in my case i can not define L3 PTP links on it.Reg...
Hello LeoI have done exactly the same configuration like shown in the document. I will go to customer site and try to run debug dhcp on the 6500 and see whether i am able to get broad cast on vlan2 or not.Regards
HiThe PCs are behind non-cisco(i.e. Marconi ASX 1000) switches, but when i put DHCP on vlan 1 on 6509 then pcs are able to get ips but when i change the vlan of DHCP to vlan 2 then pcs are not able to get ip frm DHCP.Regards
