Hi,I would like to limit the visibility to certain interfaces on a router. for example I don't want the dialer interface to be seen by SNMP. What command could I use to do that?Thanks,Olivier
Hi All,I have a router with a WAN link at 8Mbps. I have 2 classes. In the policy map, one class has a bandwith statement of 7000kbps, one has a bandwidth statement of 80kbps. The class which has a bandwidth statement of 7000kbps is not used at all....
I have a serial interface on a router with X25 configured. this serial interface is attached to a device which is making x25 calls. This device is supposed to pick the X25 address from our interface. but I can't get any x25 call. Show x25 vc doesn't ...
