I have upgraded cisco NCS-5504 router . Router was successfully upgraded but all the line cards are not showing. In platform command type is unknown and state is SW_Inactive.Regards Salman
Hi Team,By mistake i have been deleted root credentials on my NCS-5504 XR . Now i am unable to login router. Any procedure how to recover the credentials.RegardsSalman+919871873874
Facing issue with VRRP, when upstream router5 initiate traffic for downstream router6 then return traffic is not following VRRP VIP as Gateway. In my case switch2 is master and switch3 is standby.If Router6 initiate the traffic then VRRP working fine...
Hi Marce 1000,I have upgraded to 7.10.1 in NCS5504 router now line card NC57 is showing but i have two line card only single line card is detected. Regards
Hi,See when Router5 initiate traffic then traffic reached at Router6 and at the time of return traffic it will do to VRRP master switch (Switch2) but this is not happening.My only question why at the time of return traffic router6 not going towards V...
