Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I'm currently monitoring a Catalyst 8500-20X6C using SNMP, and I'm trying to retrieve hardware status values such as fan states, power supply status, and temperature sensors.
I'm using OIDs from the CISCO-ENVMON-MIB, including:
1.3.6...
Hi,
How to definitively and predictively define the master of a stack of switches from the 9300X series in a basic configuration and/or in the stack cabling?
Thanks,
Regards
Hello,
in a production environment, Cisco ISR4K devices have been upgraded from IOS-XE version 16.12.5 to version 17.3.4a without encountering any licensing activation issues during reboots and upgrades.
It should be noted that the equipment is offli...
Hello,
We are observing a change in behavior of the mls qos on the 2960 switch series between IOS 15.2.(4)E6 and 15.2.(7)E5.
The applied configuration is as follows:
mls qos map cos-dscp 0 0 0 0 0 0 0 0
mls qos map dscp-cos 0 1 2 3 4 5 6 7 to 0mls qo...
Hello,
On the Catalyst 9200 series, particularly the 9200CX and 9200L models, when the boot value is not defined, the equipment starts in Rommon mode.
When the boot value is defined with a specified *.bin file, it starts correctly with the defined...
I'm sorry but I disagree.
The stack master will have this numbering:
interface TwentyFiveGigE 1/0/1 - 24 or interface range TenGigabitEthernet 1/1/1 - 8;
whereas the third member will have:
interface TenGigabitEthernet 3/1/1 - 8 or interface range Tw...
The requirement is primarily the definition of port numbering, which must always be the same because it is defined in an orchestrator and used for a hard-coded purpose.
It is necessary that the order of switch election is always the same and as prev...
Hi,
The architecture of our sites and the configuration that we manage must ensure that in a nominal state, it is always the same switch that is the master. I cannot rely on the MAC address.
The switch priority is indeed set to define the election or...
Hello,
Thank you for your response.
I have noted the change in the licensing policy. It was already taken into account in version 17.3.4a, but the behavior seems to change in version 17.9.5a during certain restarts and the maintenance of license acti...
