Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I don't have a lot of experience with WAN routing, so this issue I am facing is perplexing. I have two WAN routers in two different geographical locations that are virtually connected via a tunnel. Recently we have been experiencing occasional ...
Hello,I am using a Cisco WLC 9800 with software version 17.9.3. My access points are 2700's and 3800's and are in local mode. I implemented a consent page with LWA around two months ago. For the first month and a half, except for a few rare issues, w...
Hello,I am using a Cisco WLC 9800 L running 17.9.3. I am attempting to set up LWA. Everything is working well in the tests I have conducted, except for the WLC is failing to remember the MAC addresses of sleeping clients. As soon as a client disconne...
Hello,I am using a WLC 9800 and I recently replaced my Aironet 2702's with Aironet 3802's. With the 2702's we had no issues and little downtime. However, since replacing them with 3802's, we're having a problem where randomly during the day, all of o...
1.) ISR 4000 series on both sides.2.) 17.9.5, but this issue has occurred on past software versions.3.) I believe MPLS, but I could be wrong. I will have to look into that further.4.) IPSEC5.) I am not permitted to.6.) %LINK-3-UPDOWN: Interface Gigab...
I increased the EAPOL-Key Timeout to 5000 ms and the EAPOL-Key Max Retries to 4 and decreased the idle timeout to the minimum 15 seconds. It seems to be working so far and clients are being saved to the sleeping client database before being deleted.
Here is a more detailed debug:2023/08/08 17:20:10.627client-authInitiated layer 3 authentication with local web-auth2023/08/08 18:13:28.867client-keymgmtReached maximum retries for M52023/08/08 18:13:38.867client-orch-smController initiated client de...
I successfully upgraded today, but didn’t fully read your reply and missed the link for the bug about older AP’s remaining in the downloading state. Since we are still using a couple of 2700’s in our network, I had to roll back to 16.12 for now. I wi...
