Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So this is what my network looks like,ONR (huawei hg8240t5 router cannot be disabled) -> c921-4p -> switches etc. etc.'If I connect directly to my ONR and try to browse IPv6 websites it works fine, I can even see my ipv6 address.My ONR is already do...
I just want to know if the configuration in the last diagram below is possible. And of course if I can get some advice on setting up the router and switch configs that would be greatly appreciated as well as this is my first time using Cisco IOS.So b...
I am using an isr c921-4p. The system file is flash:c900-universalk9-mz.SPA.158-3.M6.bin.I want to upgrade the encryption algorithms so that it’s more secure. I tried to follow this guide, https://community.cisco.com/t5/networking-knowledge-base/conf...
I tried to configure the ssh on my c921-4p, I generated 1024 bit keys. Now when I try to connect using this, ssh [email protected] I get this error on my Mac OS terminal Unable to negotiate with 10.0.0.254 port 22: no matching key exchange method foun...
I am totally new to cisco and networking in general. I am using a CBS350-16T-2G. I got it because my ISP's ONR HG8240T5 is horrible, it only lets me assign 16 ip addresses using mac addresses and does not let me create subnets/vlans. It also does not...
So I tried some commands, I did, ipv6 address autoconfig, followed by show ipv6 interface GigabitEthernet 4 (my wan port), this is the outputGigabitEthernet4 is up, line protocol is up
IPv6 is enabled, link-local address is FE80::BA11:4BFF:FE47:9FB...
@Harold Ritter So I checked there’s no nat6, so does this mean I won’t be able to get ipv6 local addresses or route ipv6? Locally or browse websites? I’m actually using a cbs350 switch below the router, can I somehow patch it together so I am able to...
Hi @Harold Ritter 1. I just picked a random address for that. I didn’t know what else to do.2. #show ipv6 routeIPv6 Routing Table - default - 3 entriesCodes: C - Connected, L - Local, S - Static, U - Per-user Static routeB - BGP, R - RIP, I1 - ISIS L...
