Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have many Meraki accespoints running in "low power mode" (Meraki MR44). The accesspoints are connected to POE switches like 1000 or 9200L or 3650 etc. Booting the AP sometimes resolves the problem, sometimes not. The FIX for this problem is to p...
We have Meraki MR36H accesspoints with "wired_only" SSIDs connected to our MX95 custer. When a device is connecting to one of the physical ports, it authenticate and gets the correct vlan by asking our Cisco ISE. This works fine and we can run both...
Regarding traps generated by a Cisco FPR-1000 unit. We receive SNMP Traps to our surveillance system. The trap has OID: 1.3.6.1.2.1.88.2.0.2. This is the message: [1]unkVar1=E1/9 interface threshold reached[2]unkVar2=[3]unkVar3=[4]unkVar4=1.3.6.1.2.1...
Fellows, we have two c8300 running software 17.03.04a IOS-XE. They keep sending snmp traps with "No Rum Reports available to process" (1.3.6.1.4.1.9.9.831.1.0.30). This is a trap in the Cisco MIB "ciscoSlaMIBNotifs"...however, I can't find any defini...
We are using the Cisco ISE and one of the appliance servers is not calculating used disk space correctly...it states 75%, but it should be more like 70%. We have the threshold snmp trap set to 25 ( =75% used ) and the server started to send alerts re...
