About bianderson

bianderson · 12-16-2003

Hi,I was wondering if anyone can help. We have a situation where a customer is experiencing some virus outbreaks and we can usually identify where it's happening by patterns in the IP accounting database. The customer has a VPN based network manage...

bianderson · 06-10-2005

Hi, you could create a small IVR using unity then instead of using the dial by name function, you could use the caller input function to redirect you to one of 3 call handlers. This will transfer to any line appearance, or you could create CTI rout...

bianderson · 03-28-2005

Hi,Make sure that your "inbound" voip leg has the "dtmf-relay H245 alphanumeric" command. The default dial-peer has no dtmf relay support so you will either have to match the inbound leg to an existing DDI dial-peer with the "incoming called number ....

bianderson · 03-28-2005

Hi, You have a problem here. You are correct that fax passthrough uses the G.711 Codec to upspeed. You will either have to support G.711 on the WAN (configure passthru on the FXS Router) or replace the ATA with another FXS based device as ATA's don...

bianderson · 01-11-2005

Hi,If you are wanting to do this, Q.931 or QSIG is the way to go, but the Panasonic may not support some of the features of Q.931 or QSIG. The most transparent way of doing this is TCCS and nailing up the d channel over the WAN, and using VAD on the...

bianderson · 10-27-2004

Check your Network cable is connected. I've seen cased where a disconnected NIC can stop the DBL service starting.HTHBill

Member Since	‎03-11-2003 03:23 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	62
Total Helpful Votes Received	20

User Statistics

User Activity

IP Accounting Overhead on Cisco Routers

Re: Displaying Original Called Number to IP Phones

Re: DTMF tones not passed out H.323 gateway

Re: fax passthrough and G729 codec in the WAN

Re: E1 connection between two PBXs and 1760s

Re: The Database Layer Monitor service does not start