Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Cisco Support,I have a CUCM6.0 server with IVR 5.0 integration.I have an issue when calling Cisco IVR..in deed, IVR doesn't disconnect the call once we hungup the call from internal/external.Can you please give me some clues to fix itMany Thanks...
Hello,Could you please send me some clues on how to activate CRS in UNIFIED-CM-6.0 in order to setup/configure the AutoAttendant.CRS software is already included in UNIFIED-CM-6.0, right?Many ThanksMF
Hi dear,Could i ask you please to tell me how can i change the IP Phones displays from English to french version on CUSM 6.0(1) version.Thanks in advanceMF
Hi dear,I configured an MGCP gateway on the Cisco Unified Communication 6.0(1). I noticed that when i placed a call from the PSTN to the IP Phone though MGCP gatway, the IP phone rings which is normal but still rings when i hung up the call..Could yo...
Hi dear,i configured two (2) 4400 Series WLAN Controller as cluster (one primary and one secondary - Active & standby)...It works fine...But i have only one concerns:During my clustering tests, i noticed that when i switch-off the primary all Lightwe...
Hi,yes, it happens for the internal and external calls.IP Phone <-> IP Phone (internal calls)IP Phone <-> PSTN (external calls)And even, i reject the call for both scenario, the Ip phone still ringsThanksMF
