Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been troubleshooting a WLC 2106 that I was given for my learning lab. I powered the device up using my power supply from my ASA 5505, there was no console output and a green power light with an amber status light. I know the general consensus....
I will include a post of my config. I have the clients connecting through the VPN tunnel on the 180.0.0.0/24 network, 192.168.1.0/24 is the primary network for the office. I can connect to the VPN and I do recieve the correct address assignment. I be...
Hey All, I appreciate any input you can throw at me.I am getting a network setup for my aunt at her office and she does not have the most expendable budget at this time. What I am looking to do it create less clutter in her network closet while makin...
Sorry, I was thinking the cable co assigned you a router. That's odd that you do not receive a consistent address, I have Comcast and I have had the same dynamic IP for a while.Maybe you can call the cable Co. and explain what you are trying to achei...
I have never used the SDM, but if you have a console cable just apply the basic config below.en conf thostname change meinterface fe 1ip address 192.168.1.1 255.255.255.0no shutexitip dhcp pool name menetwork 192.168.1.0 255.255.255.0exitservice dhcp...
have you tried writing the new ios file to the flash? When I upgraded the ios on my 5505 I just did it from the cli by copying over the new file via ftp and deleteing the old one.You may also have to update the ASDM. Read the release notes to know fo...
I had a similar issue when I was working with the Catalyst 4948 this summer for a customer. The way I got the mac address-table to populate was to ping the device from the switch. I just threw together a quick text file and had to run through the en...
