Setup:PC <-> Cisco-Phone <-> Switchportcommon PC config: PC send untaged frames, this means no 802.1q tag, and therefore no 802.1p tag and therfore no cos info However PC sends pacets marked with dscp value...
Hello everybody!I've 2 questions related to above topic:1.) how do I get the vrf information for a route beeing changed.2.) how do I track all routes in the routing table. including default-route The following command: event routing network 0.0.0.0/0...
Hello Jeff!Thx for your quick response. But the "switchport priority extend cos" will only support dot1q tagged frames received from the PC. The PC however does not send any cos info, because it is not attatched to the switch via trunk. However, it ...
Hi Joseph!Thx for your reply. I found the same fot the VRF thing and changed the applet to:event manager applet route-table-monitor event tag e1 routing network 0.0.0.0/0 ge 1 vrf name mandant1 maxrun 2 event tag e2 routing network 0.0.0.0/0 ge 1 vrf...
