Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Quick question for you PIX Gurus.I have a customer that has a setup similar to the one detailed here:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094cea.shtmlThis works fine as far as remote users being able...
I had to replace a 7940 with 7960s for two users. I associated the new devices with the users and checked the ICD ext. I also re-added the users as resources in the CSQ. Stopped and restarted the CRS engine. However the users still get Unable to log ...
Group,I need some help with scripting a simple ICD script. I'm currently using the default ICD script, which I have modified to play MOH, but that is about it. I need to configure this script to send incoming calls to VM after hours and also after a ...
Jason,I hope you found the answer to this. TAC told me the same thing as Paolo "The workaround is to run the gateway as H.323" which is unacceptable in my book. I was able to find the answer by digging around the support forums. I had the same issue....
Much appreciated guys. Too bad they have 506s and can't upgrade to 7.0. I guess the MS PPTP workaround will have to suffice for now.Thanks again for the replies!
Andy,Thanks for the sample script! This should get me started. Couple of quick questions: Should the 1234 be a CTI Port or CTI Route point?, does it need to be associated with the JTAPI user?, is there anyway to add a schedule to this script so that ...
Vance,Unfortunately, I have the DL320 with 2 17GB SCSI drives and I'm unable to install CCM on it. I get through the entire OS install and then I get a BSOD -Inaccessible boot device. Do you have any tips on how to get around this?Thanks,Larry
