Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've trying to implement DHCP accounting using RADIUS. All configuration made as in http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00801543c7.htmlbut it seems that named accounting lists not work att all.I.e.aaa a...
We using Cat2950 with /c2950-i6q4l2-mz.121-22.EA7.bin and trying to implement periodic radius accounting for 802.1x session. According to docs we've made following configuration:aaa accounting update periodic 1aaa accounting dot1x default start-stop ...
On catalyst 2950 with c2950-i6q4l2-mz.121-22.EA1.bin we have command "rtr key-chain <name of key-chain>". But I can't find command "key chain <name of key-chain" for configuring password key-string for RTR/SAA authentication. So, how can I uses RTR/S...
On catalyst 2950 with c2950-i6q4l2-mz.121-22.EA1.bin we have command "rtr key-chain <name of key-chain>". But I can't find command "key chain <name of key-chain" for configuring password key-string for RTR/SAA authentication. So, how can I uses RTR/S...
Thanks for the link, I've missed following prereq: DHCP accounting can be configured only for DHCP network pools in which bindings are created automatically and destroyed upon lease termination or when the client sends a DHCPRELEASE message.
We have 3560 with ip routing enable, and route traffic between two vlan interfaces sucessfully. But how can we monitor traffic volume that is routed by 3560? snmp-counters on those two vlan interfaces show only packets that destined to ip address of ...
Check the lower level. I.e. DSL line itself. When we encountered the same situation, than after some investigation we found that client DSL line was flapping.
c2950-77#conf tEnter configuration commands, one per line. End with CNTL/Z.c2950-77(config)#key chain ^% Invalid input detected at '^' marker.It seems that catalyst simple does not known all "key" commands. But it know "rtr key-chain...
